Tool breakage is detected in the tool breakage detection cycle called by M35. To continue operation, press the CLEAR key and then press the CYCLE START button. Stop in the single block mode if M58 is executed while this alarm message is displayed. 225 (F25)Īccumulated tool used time executed the set tool life time. Tool length measurement cycle does not start. An attempt is made to execute automatic tool length measurement cycle for the following types of tools: Back boring tool, boring tool, back spot facing tool, chamfering tool, face milling cutter and special tool. Tool measuring cycle is executed for a touch sensor or chip removing tool.Ģ. (SQ Coil No.) 224 (F24)Īlarm Name ILLEGAL TOOL FOR TOOL LGTH MEASĭescription 1. Return to Library FH-6000 (Mazatrol Fusion 640M) ALARM LIST Alarm No. Spindle load cannot be lowered even when an override value is lowered using the AFC function.Īn attempt is made to execute semiautomatic tool length measurement while the tool length measurement base is not in place.
The main transformer is exceeding 120☌ (248☏). KM11, KM12, KM18, KM76, QF7, QF8, In the compound controller unit (FRI) X1AĬONVEYOR THERMAL The thermal relay of chip conveyor or TRIP conveyor drive motor is tripped. The circuit protector in the 100 V line is tripped. Tool selection by magazine rotation stops.Ī thermal relay of auxiliary equipment motor Feed hold Spindle stop is tripped. 6 hours.Īlarm with the index table and NC positioning table driver
208, lubricating oil is not added in approx. Low hydraulic pressure state has continued for more than 2 seconds.įeed hold Spindle stop Emergency stop in 1 minuteĪlarm with the spindle lubricating oil chiller unit.Īfter the occurrence of alarm No. Return to Library FH-6000 (Mazatrol Fusion 640M) ALARM LISTįH-6000 (Mazatrol Fusion 640M) ALARM LIST If an alarm listed below occurs, it can be cleared by pressing after eliminating the cause of alarm.
0 kommentar(er)
